Recent content by itsnightime

  1. I

    Rear Diffuser Rear U Clip Replacement

    Anyone know the part # or where i can find a replacement part for the U clips that holds the rear diffusser panel right behind the rear wheels? Tried buying some from Amazon, but none seems to fit. Thanks for the help
  2. IMG_1623.PNG

    IMG_1623.PNG

    • itsnightime
    • Media item
    • Comments: 0
    • Category: Lotus Emira Photos
  3. I

    Who has Milltek's Active Controller Installed?

    This might be the issue. Reinstalled and errors are gone for now 🤞. I’ll play around with 2 and 3 settings. Drive around with #1 and no errors.
  4. I

    Who has Milltek's Active Controller Installed?

    Do you have any pictures of the pin on the controller and 2 cables?
  5. I

    Who has Milltek's Active Controller Installed?

    But either way with closed, it should not be throwing errors. Is that correct? Just trying to figure out why it’s doing the limp mode.
  6. I

    Who has Milltek's Active Controller Installed?

    It triggered about 1 minutes after installing. Then I tried clearing it and it would pop back up within a few seconds while idle. If the valves were closed, would it give this error? In case the wires were wired incorrectly from Miltek.
  7. I

    Who has Milltek's Active Controller Installed?

    I tried both fully open and OEM, button 1 and 3.
  8. I

    Who has Milltek's Active Controller Installed?

    Anyone has issues with installing the Miltek controller? Installed Greg’s cat delete but when the miltek controller is plugged in, it goes into limp mode . I ended up removing the miltek controller and keeping the decats and the code went away.
See more
Back
Top