Emira and Quick Jack

[drask25]

Hovercraft mode engaged

View attachment 54709

how did you get the lift point at the front? do you have pictures of the bottom? is it QJ 5000TLX?

 

[drask25]

Ended up ordering through Pelican Parts. Free shipping, $250 off through tomorrow, and twenty percent off accessories, plus ten percent first time customer and free shipping. 6000elx, pinch weld pucks, wall hangers, cross beam adapter: $2200

how does your plan work? do you have pictures of lifting position? I'm comparing between 6000elk and 7000tlx. I was thinking about placing 6000 slightly angled so I can reach the 4 lifting points without a cross beam. please help me

 

[Eagle7]

how does your plan work? do you have pictures of lifting position? I'm comparing between 6000elk and 7000tlx. I was thinking about placing 6000 slightly angled so I can reach the 4 lifting points without a cross beam. please help me

Don't use them at an angle like that. The QJ lifts up and backwards at the same time, so you want the rails parallel to each other. I have the 5000tlx and I set the rear rubber puck at the rear lifting location, and the front where it meets the frame rail of the car. The car's frame at the front in that area is double reinforced. The QJ comes with 2 sets of pucks; a short and tall. Use the tall set.

 

[Time2Fly]

how does your plan work? do you have pictures of lifting position? I'm comparing between 6000elk and 7000tlx. I was thinking about placing 6000 slightly angled so I can reach the 4 lifting points without a cross beam. please help me

I used the crossbeam adapter, which is also why I needed the extra step of the low profile ramps.