I’m now on my 3rd Mass Airflow Sensor

[trackday14]

It’s been 6 months since getting my first Mass Airflow Sensor replaced, now the second one has failed. Anyone else having this problem? If so, any suggestions?

Not pleased with repeat issues…they are often indicative of larger ones. If it happens again, I may offload it.

 

[Emira Fan]

When I was younger I use to put K&N filters in my cars, I had repeated MAS issues in all my cars with non-oem air filters. Tossed all the K&Ns and haven't had another MAS issue in 20 years. You're probably not running a K&N,, but perhaps you need a prefilter to help keep your intake clean.

 

[trackday14]

Thanks. Only running OEM parts…

 

[Speedy Emira]

Good idea regarding the pre cleaner but you shouldn’t be getting this issue on OEM. The filters and nothing special and conform to the standard Toyota specifications for the engine warranty.
I agree with the point on running performance oiled filter although I only had the issue after re oiling my K&N probably due to the fact I had sprayed on too much.

 

[Eagle7]

Thanks. Only running OEM parts…

Since you're tracking a lot (I assume), maybe it's a heat issue? Try some heat reflect foil tape around the wiring going into the MAF, and even that part of the housing itself. MAF's generally don't fail like that unless something is getting on them, or excessive temps.

 

[lynchy73]

Might be worth getting an auxiliary display that can display the OBD data. It would be good to have some additional data when the car is being pushed.

As suggested above, tracking the car could be the reason for/connected to these repeated issues. I mean, I’ve not heard of MAF issues, yet you’ve had repeated issues, so there must be a root cause.

Did you ever get a look at one of these bad MAF sensors?